Sloping Floor Flange (30-45 degrees) for 48mm Galv Pipe Treatment or it can be mitred

or it can be mitred at one end and used as a gooseneck at the top of the staircase or on a quarter landing or winder

although items can be supplied separately as 168M and 2 x 173F

staircases and ramps

A left-hand M6 mandrel can be purchased separately

then the IF121X-50 Ezirail Drilling Jig (For Commercial Use) would be a better choice

Sloping Floor Flange (30-45 degrees) for 48mm Galv Pipe Treatment or it can be mitredWhere would you normally use this galvanised pipe fitting? The 251 Slope Base Flange (30 degree to 45 degree) is a base flange for sloping sites, adjustable from 30 degree to 45 degree. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright